Brigmton BBOARD-60-N-A-R, Instruction Manual

- Do not overload lithium batteries. The battery pack consists of lithium 
batteries. 
 
IMPORTANT: 
Do not ride the Scooter while it is charging! 
- During charging, the LED light of the battery charger will be red. 
- When finished charging, the LED light of the battery charger will be 
green. 
- When charging is complete, disconnect the battery charger from the 
mains and the Balance Scooter. 
Steps for loading: 
- Make sure that the scooter, charger and DC power supply of the balance 
scooter remain dry. 
- Use ONLY the charger that is attached. Use of any other charger may 
damage the product or create other potential hazards. 
- Plug the power adapter into the power port on the back of the scooter 
and into a standard power outlet. - Make sure that the green indicator on 
the adapter lights up. 
- When the red indicator on the charger lights, this indicates that it is 
charging properly; Otherwise check if the line is connected properly. 
- When the indicator light on the charger changes from red to green, this 
indicates that the battery is fully charged. In this case, please stop loading 
it. Overcharging will affect battery life. 
- Charging can take up to 3 hours. Do not charge the battery for more than 
3 hours. Disconnect the charger from the balance scooter board and the 
power outlet after 3 hours. Overcharging will reduce battery life. 
- Do not charge the product for long periods of time. 
- Never charge the product without supervision. 
- The product should only be charged at temperatures between 0 ° C and + 
45 ° C. 
- If it is charged at higher or lower temperatures, there is a risk of reduced 
battery performance and potential risk of product damage and personal 
injury. 
- Charge and store the product in an open, dry area away from flammable 
materials. 
- Do not charge in sunlight or near flames. 
- Do not charge the product immediately after use. Allow product to cool 
for one hour before charging. 
- If the product is left to other people, for example, during a holiday 
period, it should be partially charged (20-50% load). Not fully charged. 
- When shipped from the factory, the product is often only partially 
charged. Keep the product in a partially charged state until it is to be used.