Brigmton BSK-1000-B-N, Instruction Manual

This skate requires maintenance of all its components, which suffer wear 
and tear due to the use of the same and is not covered by the warranty.  
 
 
CLEANING 
To clean the skate, use a damp cloth. If you need to scrape dirt, use a soft 
brush and then a damp cloth. In case the dirt is very sticky you can use a 
little toothpaste. Remember to wipe with a damp cloth after this. 
 
Be sure to keep the skid off while cleaning and make sure you cover the 
load inlet to avoid problems with the electronic components. 
 
Do not use alcohol, gasoline, kerosene or other volatile or corrosive 
chemical components. This can damage both the appearance and the 
internal structure of the scooter. Also, do not use a pressure water gun or 
running water. 
 
CONSERVATION 
Store the scooter in a cool, dry environment when not in use. Avoid leaving 
it outside, since it is not manufactured for use in wet areas, near corrosive 
agents such as seawater, ports, etc. It is also not recommended to expose it 
to high temperatures caused by direct sunlight for a long time. 
 
BATTERY MAINTENANCE 
Do not exceed the permitted operating temperature, above or below, for a 
prolonged period of time. For example, do not leave the scooter in a car in 
the sun in summer or place the batteries near the fire, etc. 
 
Avoid completely discharging the batteries, it is better to charge them 
while there is still power in them. This will prolong the life of the battery. 
Also if you drive the skate in very cold or warm areas, you can decrease the 
time of use of the batteries. It is not a failure of the batteries, but it is their 
normal behavior. 
 
Important: Even with fully charged batteries, by not using it for a 
prolonged period, you can download them. 
 
It is forbidden to disassemble the battery compartment. Only its 
manipulation in Official Technical Services or adhered Workshops is 
allowed.