background image

 

downwards when it closes. If the door moves further than the maximum distance the cord 
may wind in the wrong direction making the door open at night and close in the morning. 

 

7.

 

The door hasn’t opened in the morning and the light is flashing twice every 30 seconds.

 

(Door Closed indicator): 

If open mode is set to Light, the daylight may not be bright enough yet to make the 
ChickSafe open. The system wa

its to be sure it is daylight and may open shortly. If it doesn’t

we would suggest removing any branches or leaves that could be causing a shadow over the 

unit. For safety, if the ChickSafe isn’t sure it is daytime it will remain closed.

 Using the Time 

option for opening may be more suited for the location. 

If open mode is set to Time, check the current time and open time are correctly set. Note 
that ChickSafe uses a 24-hour clock system. 

 

8.

 

The door hasn’t closed in the evening but the light is flashing twi

ce every 30 seconds (Door 

Closed indicator): 

Is there something obstructing the door or making the door stick in its channels? Clear the 
obstacle and after 30 seconds the door will close further. 

The distance the door moves between its closed position and open position must be no 
greater than the maximum stated in the operating instructions. This is 400mm (15 inches) or 
500mm (19 inches) depending on model. Check the installation instructions supplied with 
your ChickSafe to ensure the stated distance is not exceeded. Also check the door does 

actually have a fixed end stop at the bottom of its travel (doesn’t continue down past the 

closed position if allowed to drop further) as that is what makes the ChickSafe stop running 
downwards when it closes. If the door moves further than the maximum distance the cord 
may wind in the wrong direction making the door open at night and close in the morning. 

 

9.

 

The door hasn’t closed in the evening and the light is flashing once every 30 seconds

 (Door 

Open Indicator): 

If close mode is set to Light, it may not be dark enough yet for the ChickSafe to close. The 
closing light level may be adjusted in the main menu. See the operating instructions for 
more information. 

The system has a 5 to 6 minute delay so 

that it doesn’t close the door just because someone 

has leant over it, for instance. This makes it very difficult to adjust while it is getting dark. It 
is better to make an adjustment in the menu of 10 units and see how it performs at dusk, 
then repeat on following days as necessary. 

The light level in the evening falls very rapidly from bright daylight to darkness so adjusting 
the light level may not make a very big difference to the time it closes. The most important 
thing is for all the chickens to have gone in before the door closes. 

 

 

 

Summary of Contents for ChickSafe






Reviews: