For your convenience, you can charge the battery away from the Ypush
using the special Brintal Battery Charger
35
located under the left hand
armrest. See page 20
32
This can be helpful if a mains power socket is not
available within reach of the Ypush, or for charging spare batteries.
1
Remove the battery from the right armrest compartment of the Ypush.
See page 18 for more details.
2
Remove the rubber bung from the battery socket,
36
and connect the
Brintal Battery Charger plug to the socket.
3
Check the mains power socket you are going to use is switched off. Never
connect or disconnect the Charger with the mains power already switched on.
4
Plug the Charger into the mains power socket and switch the power on.
37
5
Whilst charging, a red light
37
illuminates to indicate charging is taking
place. This changes to green when the battery is fully charged. If no battery
is connected, or the battery is fully charged and the mains power is switched
on, then the Charger will also show a green light.
6
When charging is complete, first switch off the mains power, remove the
mains plug, and then disconnect the battery from the Charger. The Charger
can be stored in the left compartment.
Note:
Do not leave the Charger plugged in with the mains power switched
off. This may gradually discharge your battery.
Note:
The battery level can be checked at any time by pressing the
check-charge button A on the top of the battery
38
Ensure the battery is
fully charged before use or storage.
Battery Charger and Charging
Charging with the battery removed from the Ypush
21
A
37
36
35
Warning!
Always charge the battery in an area that is dry and
well-ventilated and within the charging temperature range stated in the
Technical Specification.
38
A
