7
OPERATION
IMPORTANT:
This unit has been tested and sanitized prior to packing and shipping . During
transit, dust and odors can accumulate in the tank and lines . Dispense and
dispose at least one quart of water prior to drinking any water .
Turn the Dispenser On/Off
IMPORTANT:
Before you turn the dispenser on and activate the hot and cold switches, ensure
a bottle is installed .
1 .
Plug in the dispenser and turn the On/Off switch to On .
2 .
Run water through the cold and hot water taps until water begins to dispense .
3 .
To power on the cooling system, flip the cooling switch to the On position.
4 .
To power on the heating system, flip the heating switch to the On position.
Dispense Cold Water
NOTE:
Water will take approximately 1 hour after plugging in and turning on to become
completely chilled . The cooling light will turn off once the water has been fully chilled .
1 .
Press a drinking glass or container against the cold water faucet to dispense cold water .
2 .
Release when your container is full .
Dispense Hot Water and Activate Child Safety Lock
CAUTION:
This unit dispenses water at temperatures that can cause severe burns . Avoid direct
contact with hot water . Keep children and pets away from the unit while dispensing .
Never allow children to dispense hot water without proper and direct supervision .
Disable the heating feature by switching the heating convenience switch to the Off
position .
NOTE:
Water will take approximately 15-20 minutes after plugging in and turning on to reach
its hottest temperature . The heating light will turn off once the water has been fully
heated .
1 .
This water dispenser is equipped with a child safety feature in order to prevent inadvertent
dispensing . To enable dispensing of hot water, press and hold the red lock button and then
press your mug or container against the paddle directly beneath the red lock button .
2 .
Release the paddle once your container is full .
Change the Water Bottle
CAUTION:
Do not dispense hot, cool or cold water if the red light is flashing as you could empty
the tanks and cause the dispenser to overheat .
When the bottle indicator light on the front-right of the dispenser flashes red, it is time to replace your
empty water bottle with a new water bottle:
1 .
Open the dispenser cabinet door and slide the empty bottle out of the cabinet .
2 .
Remove the bottle adapter from the empty bottle and let the probe drip into the bottle . Once
dripping has stopped, place the bottle adapter on the hanger and set the empty bottle aside .
3 .
Follow the steps in
Connect a Water Bottle
to install your new water bottle .
4 .
Recycle the empty bottle at your local exchange center to receive your next bottle at a discount .
Summary of Contents for CLBL520SC
Page 11: ...11...
