11
Need help?
Give us a call on
0330 026 6273
and speak to one of our trained advisors.
Installation Cont.
1. Identify all components are present
prior to starting installation using
the diagram overleaf, and be sure to
refer to the dimensions on pages 4
& 5 for minimum and maximum wall
cavity depths.
2. Offer the mixer body (7) up to the
wall and once in the desired position,
mark and drill holes for the fixings
(23)
IMPORTANT:
Before drilling into walls,
check that there are no hidden electrical
wires, cables or water supply pipes.
This can be checked with the aid of
an electronic detector. If power tools
are used do not forget to wear eye
protection & unplug equipment after
use
3. Fit the mixer body(7)to the wall and
connect water supplies using the
nuts and olives (24); and install the
wall outlet connection (see page 13)
NOTE:
Any further tiling required,
should be completed at this stage, The
tiles should not restrict access to the
valve in order to allow for servicing of
the product if necessary.
4. Push concealing plate (8), complete
with seal (9). over the valve body and
up towards the tiled surface.
TIP:
Use a thin line of silicone based
sealant around the back edge of the
concealing plate to create a tight water
seal.
5. Push the spout on to the body
ensuring both O-rings locate within
the spout, and both locking pins
(16) lock into place, via the 2 small
holes on either side of the
spout connection. Tighten grub
screw on the underside of spout to
secure into place.
NOTE:
This fitting incorporates a
diverter feature. Simply turn the
diverter knob via the lever, in order to
change the setting from handset only
[upright position]. a combination of
handset and bath fill [central position],
and bath fill only [downwards position].
Wall Mounted Bath Shower Mixer
