12
Need help?
Give us a call on
0330 026 6273
and speak to one of our trained advisors.
Installation Cont.
Wall Outlet
There are two methods of fixing the
wall outlet depending on the type of
wall.
A. With rear access once wall is
finished:
Remove the brass backnut from the
threaded tail, and insert the wall outlet
through a 25-30mm hole in the wall
and secure with backnut.
TIP:
Use a thin line of silicone
based sealant around the back
edge of the concealing plate to
create a tight water seal.
Connect the wall outlet assembly to
the shower valve outlet (connection
not supplied).
B. Without rear access once wall is
finished:
Fit a ‘wall plate elbow’ (not supplied)
within the wall cavity and plumb
in from the shower valve. Screw
the threaded connecting tube (3)
into the ‘wall plate elbow’ using a
suitable thread sealant. The threaded
connecting tube thread (3) must
protrude from the finished wall by
5-15mm. Once the wall has been
finished the wall outlet (4) and washer
(2) can be fitted to the threaded
connecting tube, using a suitable
thread sealant.
NOTE:
The backnut (1) is not required
