Installation - Bidet Mixer
1.
Identify all components are present prior to starting installation.
2.
Fit the mixer body to the bidet ensuring the plinth (7) and washer (8) are fitted
between the mixer body and the bidet.
3.
Screw the fixing rods (11) into the bottom of the mixer body.
4.
Slide the ‘C’ shaped rubber washer (9) and ‘C’ shaped metal washer (10) onto the
fixing studs (11) up to the underside of the bidet.
5.
To secure the mixer in place tighten the fixing nuts (12) onto the threaded rods
(11) until they are fully tightened against the ‘C’ shaped metal washer (10).
6.
Screw in the flexible connecting pipes (13) and tighten by hand only (DO
NOT OVERTIGHTEN).
7.
Connect the hot and cold water supplies to the flexible connecting pipes (13).
8.
Turn on both water supplies, lift the mixer handle (3) upwards and operate in
both directions, letting the water flow for a few minutes to check all joints and
connections for any leaks.
1
3
2
4
5
6
7
8
9
10
11
12
13
11
Summary of Contents for QD 1/2 C
Page 15: ...15...
