Tools You’ll Need
Secure the taps to the basin by
using the washer and metal backnut
below the basin
3
1
2
3
4
Pack Contents
Installation Instructions
& User Guide
Pressure
BAR
1.0
5.0
0.2
4.0
2.0
3.0
60°C
65°C
Specifications
Maximum Static Pressure: 10.0 bar
Inlet Connections
Min: 0.5 bar
Max: 5.0 bar
Dynamic Water Pressure
Prior to Installation
Flat screwdriver
Adjustable spanner
Pipe cutter
Installation
60-65
°
C
recommended
Please leave these instructions
with the end user
Product code: Z2 DUS 1/2 C D4
All products manufactured and supplied by Bristan are safe
provided they are installed, used correctly and recieve regular
maintenance in accordance with these instructions.
This product has been tested to the Water Regulations Advisory
Scheme (WRAS) and satisfies the requirements of the Water
Supply (Water Fittings) Regulations 1999 and current bylaws.
For full Installation Requirements & Notes (IRN)
please visit
wras.co.uk/directory.
We recommend isolation valves to be fitted to the inlet water
supplies to ensure ease of future maintenance.
Before installing these taps the water supply must be thoroughly
flushed in order to remove any swarf, solder etc.
This product must not be modified in any way as this will
invalidate the guarantee.
Spare Parts For Your Tap
1.0
5.0
Pressure
BAR
4.0
2.0 3.0
0
Place the plinths over the holes
in the basin ensuring that the
washers are fitted between the
plinths and the basin.
Fit the taps to
the basin.
Depending
on chosen
hot or cold
water supply,
fit indice
(supplied)
x1
x1
x1
x1
Turn on
water
supply
1/2” Male BSP Tap connector
To replace any spare parts
for your tap, why not
scan the QR Code or
visit
www.bristan.com
and search for your product.
Please ensure
that the correct
colour indice is
fitted
Important
5
6
Turn
on water
supply for a
few minutes and
check all joints and
connections for any
leaks.
Operation
Push down
to get flow of
water
If the supply pressure is above 3 bar, a
pressure reducing valve must be fitted
Cross Screwdriver
The tap will shut off up to
15
±
5 seconds*
Connect the
hot or cold
water supplies
to the threaded
tails.
Please fit the
basket filter
washer into the
tail in the order
shown
If the supply
pressure is above
3 bar a pressure
reducing valve must
be fitted
Important
The Flow Valve is timed and will
shut off in 15 ± 5 seconds
*This will vary depending on system pressure
Basket Filter
washer x1
Maximum Operating Temperature
Indices
x2
Red
Blue
5/Ltr Flow Regulator
Pre-Fitted
