Document: SLSA-MIP-5-4-0-US
Date of Issue: 05/2016
Revision: -
9-5
At installing proceed according to Fig. 9-3.
Screw the finger screen (2) into the root tank rib
– use LOCTITE 565 or equivalent
sealant.
Connect fuel hose (3) on the finger screen.
Install the wing
– see 4.3.2.
Check fuel system tightness (see 9.4.1).
Fig. 9-3
Removal / Installation of the finger screen
1 - Fuel tank
2 - Finger screen
3 - Fuel hose
4 - Clamp
9.3.5
Fuel level sender removal
Type of maintenance: line
Authorization to perform:
Sport pilot or LSA mechanic
Tools needed:
electric drill
drill bit diam. 3.2 mm (1/8 in)
screwdriver
cutting pliers, pliers
Remove the wing
– see 4.3.1.
Disconnect fuel level sender wire.
Unscrew bolts and remove fuel level sender from root fuel tank rib.
9.3.6
Fuel level sender installation
Type of maintenance: line
Authorization to perform:
Sport pilot or LSA mechanic
Tools needed:
wrench size 8
screwdriver
riveting pliers
cutting pliers, pliers
Set sealing on the fuel tank flange.
Set position and length of the fuel level sender lever according to Fig. 9-4.
Summary of Contents for S-LSA
Page 2: ......
