REFRESH
INSTALLATION, OPERATION AND MAINTENANCE MANUAL
Assembly, Installation and Commissioning
2.2.4
Refresh Mini, Midi & Maxi Assembly Procedures
The following procedures cover only the Refresh Midi, Maxi and Ultima units as these units require
assembly. The refresh Mini is supplied a one-piece unit.
Step 1:
Prepare a clear & level area around the proposed installation area in accordance with
the drawings with approximately 1 metre clearance all-round the unit for access.
Note: The unit must be installed on a level surface.
Step 2:
Install the bottom unit in the proposed installation area.
Step 3:
Using the spirit level, make sure the bottom unit is level. Adjust the feet accordingly as
necessary and then recheck the level.
Step 4:
Using safe and suitable methods lift and then position the first half of the unit on top of
the base and lock into position.
Step 5:
Assemble the filters and cover panels to the unit as necessary.
2.2.5
Refresh Ultima Assembly Procedures
Services Tower:
Step 1:
Prepare a clear & level area around the proposed installation area in accordance with
the drawings with approximately 1 metre clearance all-round the unit for access.
Step 2:
Safely locate the base of the refresh unit at the correct location and in accordance with
the drawings.
WARNING:
USE LIFTING EQUIPMENT WHICH HAS A SUITABLE SAFE WORKING LOAD FOR
THE EQUIPMENT BEING LIFTED.
Step 3:
Using the lifting equipment], lift the first half of the Services Tower unit on top of the
base and lock into position.
Step 4:
Slide the second half of the Service Tower unit into position next to the first half
ensuring it is flush.
Step 5:
Using the M10 fixings, bolt the two sections of the Service Tower together.
Step 6:
Using the spanner, tighten the M10 fixings to secure the two sections.
Canopy:
WARNING:
USE LIFTING EQUIPMENT WHICH HAS A SUITABLE SAFE WORKING LOAD FOR THE
EQUIPMENT BEING LIFTED.
Step 1:
Using the lifting equipment and height adjustable stands, assembly the canopy on a
level surface.
Step 2:
Place the spirit level on the outer edge of the upper valance to level each section.
Step 3:
Assemble the unit from its component parts.
Issue: Final
Page 19 of 70
Summary of Contents for Refresh Maxi
Page 71: ......