14
15
HOW TO SET-UP
HOW TO SET-UP
TO FIT CANOPY
A.
With the viewing window flap on the
outside, grasp the Canopy ensuring the
two plastic frame sections at both sides
are aligned.
B.
Push the two plastic frame sections at
both sides onto the Infant Carrier at the
inside of the handle pivot point.
C.
Refit the elastic Canopy strap to the
dedicated elastic trim strap on each side of
the Infant Carrier.
D.
The Canopy can be rotated to cover the
baby or opened by rotating to the desired
position.
TO REMOVE CANOPY
A.
Ensure Canopy is in the collapsed
position. Unclip the elastic Canopy straps
which are secured by plastic hooks under
each handle attachment point.
B.
Grasp the Canopy and pull it away from
the Infant Carrier ensuring the straps are
clear of catching any objects.
A
SETTING UP THE HARNESS
The Infant Carrier is fitted with three shoulder strap positions. As the baby grows
the shoulder straps must be moved to higher slots. Refer to page 16- 19 for correct
fitment of the harness shoulder straps.
A.
Sit the Infant Carrier on a flat ground
with the handle rotated fully back to
prevent rocking.
B.
Release the buckle and lengthen the
Harness Straps by pressing Harness
Adjuster (under the flap) while grasping
both Shoulder Harness Straps and
pulling out desired amount of slack.
C.
Move the two harness tongues to the
sides of the infant carrier and store in
the Buckle Tongue Holders (holders are
on both sides of the Padded Insert and
the cover). Move the harness buckle
towards the Harness Adjuster.
D.
Place baby into Infant Carrier lying on
its back so that the buckle is between
the baby’s legs.
E.
This section covers the setting up
of the harness to fit the height of the
child and fitting of the harness is
not required. Securing of the child is
covered later in the instructions.
Buckle Tongue
Holder
Lift the Harness
Adjuster and
pull the Harness
Straps to
slacken.
NOTE:
Elastic Canopy loops must always be
fitted when Canopy is in use.
