Consumer Services: 1.844.227.0300
stroller.recall@britax.com
Page 1 of 3
B-AGILE
®
/ BOB
®
MOTION
®
Instructions / Instructions / Instrucciones
Britax Child Safety, Inc., 4140 Pleasant Road, Fort Mill, SC 29708, U.S.A
© 2017 Britax Child Safety, Inc. All rights reserved.
P06095700_A:01.17
2
Britax has received reports of damaged Click &
Go receiver mounts on the stroller frame, which
can cause the attached car seat to disengage
unexpectedly, posing a fall hazard to infants in
the car seat. ONLY use your B-Agile and BOB
Motion stroller as a travel system with the new
infant car seat receivers.
New Infant Car Seat Receiver Kit:
• Infant Car Seat Receivers (left and right)
• No Tools Required
1
3
5
4
Receiver
Strap
Receiver
Strap Snap
Replacing the Infant Car Seat Receivers
Tip:
Before you begin, lock the parking brake.
1. Press the grey tab on the old infant car seat
receiver and lift upward to remove from the
stroller (Fig. 1). Repeat for other receiver.
IMPORTANT:
Discard the old infant car seat
receivers.
2. Unsnap the stroller seat strap from the frame
of the stroller (Fig. 2).
NOTE:
You will need to reattach this strap after
installing the new receiver.
3. Install the new infant car seat receivers (Fig. 3).
a. Align the receiver with the mount on the
inside frame of the stroller.
b. Push down until a click is heard. Pull up on
the receiver to ensure it is secure.
4. Attach the receiver strap snap to the frame of
the stroller (Fig. 4).
5. Attach the stroller seat strap to the receiver
strap snap (Fig. 5). Repeat for other receiver.
Receiver
Tab
Receiver
Tab
Receiver
Strap
Receiver
Strap Snap
Video Instructions:
us.britax.com/recall
