Britax Child Safety, Inc., 13501 South Ridge Drive, Charlotte, NC 28273, U.S.A
Consumer Services: 888.427.4829
www.Britax.com
© 2012 Britax Child Safety, Inc. All rights reserved.
R1:01.12
P509300
Page 1 of 2
2
1
3
5
4
Installing the Harness Adjuster
Retention Clip
1.
Lift the cover at the foot of the infant car seat and
confirm that your harness adjuster is attached to the
shell by pulling on the harness adjuster strap.
If the harness adjuster is securely attached go to step
#2. If the harness adjuster is not attached, stop here
and
discontinue use of this car seat immediately
and
call Britax Customer Service at 1-888-427-4829.
2.
Pull the adjuster strap through the
harness adjuster retention clip as
shown. (See Fig. A)
3.
Angle the harness adjuster retention clip down over the
release button assembly until the top of the clip is seated
under the edge of the shell.
4.
Press down the end of the harness adjuster
retention clip until it latches onto the end of the
infant car seat shell.
5.
Replace the cover and pull the adjuster strap
through the slot in the cover.
This completes the recall remedy.
A
Chaperone™ Infant Car Seat
Instructions / Instrucciones / Instructions
