Instructions for Installation & Use
Instructions for Installation & Use
20
21
SUITABLE FOR USE
USING THE BABY CAPSULE
REMOVING BABY CAPSULE FROM BASE
A. Grasp the handle with one hand. With the other
hand, lift the catch located at the front of the Baby
Capsule.
B. With the catch still lifted raise the Baby Capsule
clear of the base.
Pull
Catch
Lift
If the baby’s neck muscles are unable to
support their head, then the child should remain
rear-facing, choose a restraint that will suit larger
babies in a rear-facing mode.
To ensure that the space is sufficient, the purchaser should check the measurements
between the vehicle’s rear and front seats in which the child restraint is intended to be used.
Ensure babies and toddlers are adequately shaded from direct sunlight through side or rear
windows.
Check the car is ventilated by opening windows or using the car's ventilation system taking in
external air. Recirculation setting is not suitable for providing ventilation.
THE TETHER STRAP MUST ALWAYS BE FITTED WHEN THE CHILD RESTRAINT IS
USED IN A VEHICLE.
Do not use the restraint without the top tether strap correctly attached.
The top tether strap must be attached to an anchorage point using an extension strap if
necessary.
The Baby Capsule may just touch the front seat, but must not in such a way that the
installation angle is affected.
Do not recline the seat excessively, it must be
installed at the correct angle (see page 21 - 22).
Do not use on any vehicle seat which faces
sideways or rearwards.
Do not allow the front seat to alter the installed
position of the restraint, It is permissible to allow
the restraint to touch the seat in front of it.
570mm
490mm
