Instructions for Installation & Use
Instructions for Installation & Use
22
23
USING THE BABY CAPSULE
2
ADJUSTMENT OF HANDLE POSITION
The Baby Capsule features a sturdy carry handle which can be used in conjunction with
the curved base to convert it to a rocker. At the base of the handle there are two large
buttons which control the three positions of the handle. These positions are the "carry (or
travel) position" , the "rocking position" , and the "non-rocking position" .
B. Ensure the handle is locked in position securely.
The "rocking position" enables the Baby Capsule
to rock without the possibility of the Baby Capsule
tipping over.
C. To convert to a "non-rocking" position depress
both buttons and rotate the handle to the fixed
position. Ensure the handle is locked in position
securely.
A. To convert from carry to "rocking position" ,
depress the large buttons on each side and rotate
the handle towards the front of the Baby Capsule.
When you have started rotating the handle release
the buttons and continue rotating the handle around
until it locks into position.
Rocking Position
Non-rocking
Position
Carry Position
Do not place the Baby Capsule on a table or a
work-top where it could fall off.
IMPORTANT :
2
3
1
3
1
2
2
3
Remove all packaging from the Baby Capsule.
Consult the car owner’s handbook for location of top tether anchorage points.
If there is no child restraint anchor fitting or child restraint anchor point refer to pages 58
to 62 for the installation of the anchor fitting as well as the use of extension straps.
An anchor fitting is required to attach the top tether strap to fully install the Capsule to
the car. The top tether strap must be used with this Baby Capsule when used in the car.
For installing the Base to the car, select a seating position with a child restraint anchor
fitting directly behind the seating position.
ADJUSTING THE BASE ANGLE
A. Place the base and Baby Capsule on vehicle seat
in a seating position where a child restraint anchor
fitting is installed. The Level Indicator Line needs
to be level with the road, (i.e. parallel with the road
surface). Check and adjust the Levelling knob of
the base if necessary.
B. If your car’s seat is contoured then you may need
to adjust the angle of the base so your baby is not
too upright.
The angle may be altered by turning the base
levelling knob located at the rebound bar end
which will cause the levelling foot to extend from
the under side of the base.
Levelling Knob
Level Indicator Line on
both sides of base.
INSTALL INTO VEHICLE
INSTALLING THE BASE