Instructions for Installation & Use
Instructions for Installation & Use
26
27
IMPORTANT:
Do not attach the lower attachment connectors of two separate child restraints to
the same ISOFIX low anchorages in your car.
Always attach the top tether strap to the child restraint upper anchorage in your
car.
Child restraint lower attachment connectors and the ISOFIX low anchorages in your car
are designed to withstand only those loads imposed by a correctly fitted child restraint.
Tension indicators
Green when tensioned
H. Push downwards on the side of the restraint base to compress it into the vehicle
seat. Whilst compressed into the seat, pull on adjuster strap to remove all slack and
tighten the strap . Repeat for the adjuster strap on the other side of the base. The two
tension indicators will show green indicating minium tension has been applied.
G. Feed the ISOFLEX™ connector straps under the belt guide hooks as shown. Ensure
the straps are not twisted.
H
G
D
D. Place the Base in the desired location
on the vehicle seat between the two
ISOFIX low anchorages. A firm fitment
of the base in the vehicle rear seat
with the base against the seat back
and correct installation angle is very
important. The vehicle seat design
will determine if the stabiliser bar is in
contact or not, it does not need to be.
E. Engage the ISOFLEX™ connectors
onto each ISOFIX low anchorage. A
green indicator will show on the top of
the ISOFLEX™ connector when it has
engaged.
Pull each strap to ensure both lower
anchorage connectors are engaged.
F. Confirm the base angle as desired,
otherwise adjust as shown on page 23
and 24.
C
C. Press and hold the adjuster release
button and pull the connector strap
to fully lengthen it. Repeat for both
connector straps.
Green
indicator
I. Locate the child restraint upper anchorage fitting in the vehicle that is directly behind
the rear seat location chosen. Refer to the car owner’s manual for the location (If
there is no upper anchorage fitting then refer to pages 58 to 62 for instructions in
adding an anchor fitting).
J. Connect the top tether strap attachment clip to the anchor fitting in the car as detailed
on page 31. Install top tether strap to the Baby Capsule as shown on page 31.
ISOFLEX
REARWARD FACING
ISOFLEX
REARWARD FACING
HOW TO INSTALL THE BASE -
WITH ISOFLEX
™
CONNECTORS
HOW TO INSTALL THE BASE -
WITH ISOFLEX
™
CONNECTORS