Instructions for Installation & Use
Instructions for Installation & Use
40
41
HOW TO USE
CAUTION:
Do not harness an infant wrapped in a blanket or swaddled as this increases the risk
of ejection and injury or death in a crash. The harness needs to fit firmly to the baby,
any blanket or other covering may be placed over the harness after the harness is
adjusted. Arms and legs must be free and not bound. The legs must sit on each side
of the crotch strap.
HOW TO USE
E. Fit either harness buckle tongues into the harness buckle
followed by the other tongue. A click is heard when the last
tongue is fully engaged.
Should the second tongue not insert - press the red button
and reinsert the tongues. Ensure secure engagement by
pulling harness straps. If the harness buckle does not engage
correctly then it may require cleaning or need replacement,
refer to page 52.
The buckle tongues are fully engaged
when both tongues are inserted and 'click' is heard.
Tongue
Buckle
C. Place baby into Baby Capsule lying on its back so that the
buckle is between the baby’s legs. Ensure that baby’s arms
and legs are free. Make sure baby is dressed to allow the
Harness Buckle to be pulled up between baby’s legs e.g.
a jump suit.
B. Place the two harness tongues
into the Buckle Tongue Holder
(if fitted).
Move the harness buckle
towards the harness adjuster for
easier fitment next time you put
the infant in the Capsule.
NOTE:
1. Discontinue using the Padded Insert when shoulder straps
are in the top slots or if the Pad causes over heating,
discomfort or you need more room for baby to grow.
2. Correct fitment of the harness is very important as it
restrains the baby in the Baby Capsule. The harness must
fit firmly around upper torso of the baby and be positioned
so as to leave the baby’s arms and legs free.
D. Place each arm through each shoulder strap of the harness.
Position the buckle of the crotch strap as shown right.
Buckle Tongue
Holder (if fitted)
Click
