Instructions for Installation & Use
Instructions for Installation & Use
46
47
HOW TO INSTALL IN AN AIRCRAFT
AIRCRAFT
REARWARD-FACING
BELT PATH
marked in green.
FIT THE BABY CAPSULE TO THE
AIRCRAFT SEAT
The top tether strap is not required to be used to fit
the child restraint in aircraft. You do not need the base
onboard the aircraft. We recommend that you store the
excess strap and hook in the pocket provided and check-
in the base with your luggage for use at the destination.
A. Position the Baby Capsule rearward facing, align
it centrally within the allocated seating position. If
possible, lift the armrests out of the way to improve
access to installing the aircraft lap belt and to suit the
width of the Capsule.
B. Carefully remove cover on the side to reveal
AIRCRAFT
REARWARD-FACING BELT
PATH
label marked in green.
HOW TO INSTALL USING AIRCRAFT LAP BELT
The Baby Capsule without base is suitable for use on aircraft.
The Baby Capsule must be used in accordance with the aircraft operators procedures,
and any directions or instructions from the aircraft operator, pilot or crew.
The Baby Capsule may not fit in smaller aircraft and cannot be used with aircraft
seatbelts that contain airbags unless they can be disabled.
Inform the aircraft operator that a child restraint is intended to be used on the aircraft
when booking the flight as the child restraint may not be suitable for use in that
operator’s specific aircraft.
For use of the child restraint in cars in countries other than Australia and New Zealand,
The user should consult the country’s local authorities, car hire companies, car insurance
companies, etc. for advice. The child restraint may not be acceptable for use in all cars.
B
HOW TO USE
TO FIT AND USE THE CANOPY
A. Push the two plastic frame sections at both
sides onto the Baby Capsule at the inside of
the handle pivot.
B. Refit the elastic Canopy strap to the
dedicated elastic trim strap on each side of
the Baby Capsule.
C. The Canopy can be rotated to cover the
baby or folded by rotating to the desired
position.
TO REMOVE CANOPY
A. Ensure Canopy is in the collapsed position.
Unclip the elastic Canopy straps which are
secured by plastic hooks under each handle
attachment point.
B. Grasp the Canopy and pull it away from the
Baby Capsule ensuring the straps are clear
of catching any objects.
A
NOTE:
Elastic Canopy loops must always be
fitted when Canopy is in use.
AIRCRAFT US
E
B
NOTE:
Never use this path in a car. Always replace cover after use.
