Instructions for Installation & Use
Instructions for Installation & Use
68
69
* Refer to page 23 for handle position
TRAVEL SYSTEM
BRITAX CLICK & GO™ADAPTOR
TRAVEL SYSTEM
INTEGRAL LATCH
D. Then lower the foot end of the Baby Capsule until it rests on the seating surface of
the stroller.
E. Check the Capsule is securely attached to
the stroller arm bar by lifting the Capsule
before use.
F. Fold the Baby Capsule handle down if
required.
NOTE: Do not lift the stroller by the
Capsule as it may disengage.
Refer to the Stroller instruction book for all
other instructions.
REMOVING THE BABY CAPSULE FROM THE STROLLER
A. Rotate the Baby Capsule handle to the "carry position" and grip firmly in one hand.
B. Raise the Baby Capsule release catch located on the rear of the Baby Capsule.
C. Lift the Baby Capsule clear of the stroller.
ENSURE THE BABY IS SECURED IN THE BABY CAPSULE WITH THE HARNESS
AT ALL TIMES. THE BABY CAPSULE IS FITTED WITH A CANOPY WHICH CAN BE
USED WHEN THE CAPSULE IS CONNECTED TO THE STROLLER. THE CANOPY
CAN ALSO BE USED IN THE CAR.
Stroller seating surface
Only use Baby Capsule with compatible Britax/Steelcraft Stroller or with other
brand strollers that have an approved Britax CLICK & GO™ receiver.
Pull upwards on both sides of the Baby Capsule to confirm it is locked into the
frame. If not locked on both sides, repeat above steps.
IMPORTANT :
ATTACHING THE BABY CAPSULE TO THE STROLLER
FRAME
If the Baby Capsule is fitted with Britax CLICK & GO™ Adaptor, then fit as follows:
B
A. Remove Stroller seat or Carry cot from stroller frame
(refer to your stroller instructions).
B. The Baby Capsule may only fit the stroller in one
direction. The Baby Capsule should face the Stroller
handle. With the Baby Capsule handle in the upright
position, place the CLICK & GO™ adapters over the
stroller frame sockets and push the Baby Capsule into
the socket. The adapters will lock the Capsule to the
stroller.
Secure your baby into the Baby Capsule with
the harness provided on the Baby Capsule.
Britax CLICK & GO™ receiver set may be required for
compatibility with some strollers.