Instructions for Installation & Use
- Series No. BS4900A-020130
Instructions for Installation & Use
- Series No. BS4900A-020130
17
16
HOW TO SETUP
HOW TO SETUP
Seat
base
Seat
back
UNFOLDING THE BOOSTER SEAT
If the seat is in a folded position, grip the
Booster seat back and seat base and unfold
till you hear it lock into position. Check that
the seat has locked into position.
DO NOT PLACE FINGERS IN BETWEEN
SEAT BACK & SEAT BASE WHEN
FOLDING OR UNFOLDING. RISK OF
TRAPPING HAND/FINGER
CAUTION:
FOLDING THE BOOSTER SEAT
To store the Booster seat, push to fold the
seat forward.
BEFORE INSTALLING THE
SEAT IN TO THE CAR
Place child in booster seat and check height
for headrest and SecureGuard™ Device set
up. Adjust as shown on pages 17 to 19.
Extend seatbelt if required.
Check and adjust
SecureGuard™
Check headrest position
ADJUSTING THE HEADREST
A. The headrest can be adjusted to lock into different height
locations. This can be done with the child in the seat.
B. Hold backrest as shown and squeeze the headrest
adjustment handle at the back of the headrest with the
other hand, to move the headrest up or down.
C. Adjust the headrest height so that the bottom of the sash
guide is level with or just above your child’s shoulder
(but not more than 30mm above).
D. When the headrest is in the correct position let go of the headrest adjustment handle and
ensure it has locked into place.
Do not adjust the headrest by pulling on the Side Impact Cushion.
Keep hands away from gap at the back of the lower
backrest whilst adjusting.
CAUTION:
B
Less than
30mm
Greater than
30mm
CHILD USE
(BOOSTER SE
AT
MODE)
CHILD USE
(BOOSTER SE
AT
MODE)
