13
Remove Device From a Network Group
If you would like to remove device from a network group, you can generate a new group name for
the device that you would like to remove by following the Step I. This makes the device not able to
communicate with the original network group.
Create Private Network
If users want to make devices become private or separate devices from one group to two or more
network group, please follow
Step 1
on those devices, and after that,
take
Step 2
. Then private
network with random name is created.
P.S. Users can press the RESET button to reset the network name back to its factory default.
Standby Mode
If no Ethernet cable is connected to the
Powerline Ethernet Bridge
within two minutes after
powering it on, this device will go into standby mode automatically, in order to lower power
consumption. Meanwhile, the POWER LED will blink ON and OFF at a slow rate. To exit the
standby mode, insert the Ethernet cable or re-plug in this device to the electrical outlet.
Note:
1. Some computers support “Wake on LAN” and it may cause the Ethernet adapters to stay
on without entering the standby mode.
2.
Powerline Ethernet Switch
does not go into standby mode.
Summary of Contents for BVH-5101
Page 1: ......
Page 2: ......
Page 29: ...28 Administration Management System Management ...
Page 40: ...28 ...