7
500 Mbps Powerline Bridge (BVP-5100)
LEDs
Power LED
Green
ON: Power on and ready.
BLINKING:
During
group pairing procedure (creating an encrypted PLC
network)
. In this procedure, the device is creating or being joined into
same logical network and will continue 2 minutes blinking, until the
procedures succeed or canceled. To enter or cancel
group pairing
procedure
, just press the group button 2~3 sec.
OFF: Power off.
PLC LED
Green
ON: Powerline link with other PLC device but no powerline traffic.
BLINKING:
1.
Fast blinking
: Powerline data rate higher than 80Mbps.
2.
Normal blinking
: Powerline data rate between 40Mbps to 80Mbps.
3.
Slow blinking
: Powerline data rate slower than 40Mbps.
OFF: Powerline link not detected (either other devices in same network is
too far to communicate or it is alone in its logical network).
WLAN Link / Act LED
Green
+
Red
Steady
Green
: Wi-Fi active under security protection
Flash
Green
: Wi-Fi transmits packets under security protection,
Steady
Red
: Wi-Fi active under NO security protection,
Flash
Red
: Wi-Fi transmits packets under NO security protection,
Blinking
Green
: WPS negotiation
OFF
:
Wi-Fi off
Summary of Contents for BVH-5101
Page 1: ......
Page 2: ......
Page 29: ...28 Administration Management System Management ...
Page 40: ...28 ...