ENGLISH
USER MANUAL
BRITEQ
®
7/18
BT-CHROMA800
DIMMER SPEED
Used to set the speed (smoothness) of the dimmer continuously.
•
Press the ▼/▲ buttons to browse the menu until the required function shows up.
•
Press the ENTER button: the values can be changed
•
Use ▲/▼ buttons to select the desired speed:
•
000 (0ms):
The projector follows the instructions instantly, no delay (also called LED behavior).
…
•
255 (2000ms):
The projector imitates the behavior of a halogen lamp (slower reaction time).
•
Once the desired value shows on the display, press the ENTER button to confirm.
Remark:
The default value (100 or 440ms) is the most realistic value to imitate “halogen lamp” behavior. At
the same time the light output will be instantaneous while pushing a flash button on your DMX-controller.
DIMMER CURVE
Used to set the dimmer curve of the master dimmer.
•
Press the ▼/▲ buttons to browse the menu until the required function shows up.
•
Press the ENTER button: the values can be changed
•
Use ▼/▲ buttons to selected the desired curve:
•
Once you have the desired curve, press the ENTER button to save it.
FAN SPEED
Used to adapt the speed of the cooling fans.
•
Press the ▼/▲ buttons to browse the menu until the required function shows up.
•
Press the ENTER button: the values can be changed
•
Use ▲/▼ buttons to select the desired speed:
•
AUTO:
The fan speed is temperature controlled for the best possible balance between performance
and LED temperature (default mode).
•
LOW:
The fan speed is temperature controlled for the best possible balance between performance
and low noise. The fan speed is limited so the output will be reduced when the temperature is high.
•
HIGH:
The fan speed is temperature controlled for the best possible performance. The fan speed is
higher so it will produce more fan noises.
•
Once the desired value shows on the display, press the ENTER button to confirm.
STAND-ALONE menu
WORKING MODE
Used to select the desired working mode while the projector is in stand-alone mode
•
Press the ▼/▲ buttons to browse the menu until the required function shows up.
•
Press the ENTER button: the values can be changed
•
Use ▼/▲ buttons to select the desired mode:
•
SLAVE Mode:
The projector copies the light output of the master (working in stand-alone mode)
•
MASTER: Full on:
The projector works in MASTER Mode with no running program, you can choose a
color with the Color Effects option.
•
MASTER: Program 01-22:
The projector works in MASTER Mode, you can select one of the internal
pixel programs (also select program speed)
•
Once the desired value shows on the display, press the ENTER button to confirm.
PROGRAM SPEED
Used to select the desired speed of the selected pixel program
•
Press the ▼/▲ buttons to browse the menu until the required function shows up.
•
Press the ENTER button: the values can be changed
•
Use ▼/▲ buttons to select the desired speed: 000 (slow) → 255 (fast)
•
Once the desired value shows on the display, press the ENTER button to confirm.
Remark: the program speed depends on the amount of Afterglow: reduce the afterglow value if the program
speed is not high enough.
