ENGLISH
OPERATION MANUAL
BRITEQ
®
9/64
LDP-COBWASH 60TC + 150TC
Once the correct option shows on the display, press the ENTER button to save it.
NO DMX BEHAVIOR
Used to set how the projector reacts when the DMX-signal suddenly disappears.
Press the MODE button until the desired function is showing on the display.
Press the ENTER button: the values can be changed
Use DOWN and UP buttons to select the desired mode:
BLACKOUT
output turns black while no DMX is detected.
FREEZE:
output based on the last valid DMX-signal is kept on the projector.
Once the correct option shows on the display, press the ENTER button to save it.
Note:
as soon as the input detects a DMX-signal, blackout or freeze mode will be cancelled.
DEFAULT SETTINGS
This is your emergency exit if you really messed up the settings: just return to factory settings.
Also 2 user settings can be saved/loaded.
Press the MODE button until the desired function is showing on the display.
Press the ENTER button: the values can be changed
Use DOWN and UP buttons to selected the desired settings:
FACTORY
USER1
USER2
Press the ENTER button:
FACTORY
was selected: the display shows
“LOAD”
Press the ENTER button: the display shows “CONFIRM?”
Use DOWN and UP buttons to select YES / NO
Press the ENTER button to confirm.
USER1 / USER2
was selected: the display shows “ACTION?”
Use DOWN and UP buttons to select LOAD / SAVE
Press the ENTER button to confirm: the display shows “CONFIRM?”
Use DOWN and UP buttons to select YES / NO
Press the ENTER button to confirm.
SAVE
was selected: the current settings of the setup menu are saved to memory.
LOAD
was selected: the previously saved settings are loaded.
FIRMWARE VERSION
Used to show the current version of the firmware.
Press the MODE button until the FIRMWARE is showing on the display.
The firmware of this unit can be upgraded using a special upgrade tool with Windows
®
software. (separately
available from Briteq).
Each time the projector is switched on, the display
shows “UPDATE Wait ….”: while this message shows on
the display you can start the update using our special upgrade tool. More information about this can be found
in the user manual of the upgrade tool and / or our website:
www.briteq-lighting.com
RDM FUNCTIONS / REMOTE SETUP
RDM
means “
R
emote
D
evice
M
anagement”. This projector works with a brief set of RDM-functions which
means that it can setup a bi-directional communication with an RDM-compatible DMX-controller. Some of
these functions are briefly explained below, others will be added in the future.
The DMX-
controller sends out a “discovery command”, all RDM devices respond and send their unique
device ID.
The DMX-controller asks each RDM device for some basic data so it knows which devices are connected.
The projector will respond:
Device name:
the actual name of the unit
Manufacturer:
Briteq
®
Category:
LED Dimmer
Firmware:
x.x.x.x
(firmware version of the projector)
DMX address:
xxx
(current DMX start address of the projector)
DMX footprint:
xx
(number of DMX-channels used by the projector)
