Briteq LDP COBWASH Operation Manual Download

Page: 6 / 68

ENGLISH

OPERATION MANUAL

BRITEQ

4/64

LDP-COBWASH 60TC + 150TC

IR-REMOTE

Note:

Make sure that the IR-remote option in the setup menu is switched on before you start using the

remote control.

1. BLACKOUT-button:

used to switch the output ON/OFF

2. SPR-button:

used to select one of the pre-programmed static colors of the projector. First press the

SPR-button, followed by one of the 10 number buttons to select the desired color.

3. COLOR (NUMBER) buttons:

each buttons represents a color.



1-button:

warm white



2-button:

cold white



3-button:

red



4-button:

orange



5-button:

yellow



6-button:

green



7-button:

cyan



8-button:

blue



9-button:

purple



0-button:

custom color (previously saved in memory)

4. AR-button:

used to select one of the effect programs. With

each press you go to the next effect:



Press 1x:

Color change 7colors selected



Press 2x:

Color change 3colors selected



Press 3x:

Color fade effect selected

5. FL-button:

used to switch the strobe function ON/OFF. First

press the FL-button, followed by the ±buttons (7) to adjust
the strobe speed.

Remark:

works on the effect programs.

6. SP-button:

used to adjust the speed of the effect programs. First press the SP-button, followed by the

±buttons (7) to adjust the program speed.

7. ±-Buttons:

used to increase / decrease the value of the selected function.

8. CUSTOM COLOR ADJUST-buttons:

press one of these buttons to select the static custom color and

adjust one of its color components:



Press the R-button:

followed by the ±buttons (7) to adjust the red component in the custom color.



Press the G-button:

followed by the ±buttons (7) to adjust the green component in the custom color.



Press the B-button:

followed by the ±buttons (7) to adjust the blue component in the custom color.

9. D-button:

not used for this projector.

10. S-button:

used to switch the projector to DMX-mode and set the DMX-address remotely. Below an

example is shown to set DMX-

address “437”



Press the S-button:

output turns red.



Press 1

number button (3):

in this case button

“4” , the output turns green.



Press 2

number button (3):

in this case button “3” , the output turns blue.



Press 3

number button (3):

in this case button “7” , the output flashes 2 times to indicate that the

new DMX-address is accepted.

11. SA-button:

not used for this projector

12. SL-button:

not used for this projector

13. Battery compartment:

receives a CR2025 3V-battery (supplied).

OVERHEAD RIGGING



Important:

The installation must be carried out by qualified service personal only. Improper

installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.



Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging

and servicing.



Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The

fixture must be fixed

at least 50cm

from surrounding walls.



The device should be installed out of reach of people and outside areas where persons may walk by or be

seated.