ENGLISH
OPERATION MANUAL
BRITEQ
®
7/64
LDP-COBWASH 60TC + 150TC
DMX ADDR
Used to set the desired DMX-address.
Press the MODE button until the desired function is showing on the display.
Press the ENTER button: the values can be changed
Use DOWN and UP buttons to select the desired DMX512 address. The last occupied DMX-address is
also shown: makes it easier to set the address of the next unit in the chain.
Once the correct address shows on the display, press the ENTER button to save it.
Note:
on RDM-compatible controllers this option can also be remotely set.
CH. MODE
Used to set the desired channel mode.
Press the MODE button until the desired function is showing on the display.
Press the ENTER button: the values can be changed
Use DOWN and UP buttons to select the desired mode:
CH:03
R, G & B can be set separately, no master dimmer.
CH:04
R, G & B can be set separately, with combined master dimmer on CH4.
CH:04+
R, G & B can be set separately, with master dimmer on CH4. (no strobe)
CH:06
R, G & B can be set separately, with separate master dim, strobe and color fade channels.
Once the correct option shows on the display, press the ENTER button to save it.
Remark:
on RDM-compatible controllers this option can also be remotely set.
SLAVE MODE
Used to set the projector as slave in a master/slave setup.
Press the MODE button until SLAVE MODE is showing on the display.
IR-REMOTE
Used to set the wireless remote function on/off.
Press the MODE button until the desired function is showing on the display.
Press the ENTER button: the values can be changed
Use DOWN and UP buttons to select the desired mode:
OFF
The unit does not accept commands from the supplied remote controller.
ON
The unit can be controlled by the supplied remote controller.
Once the correct option shows on the display, press the ENTER button to save it.
EFFECT MODE
Used to set the desired effect mode while used as master.
Press the MODE button until the desired function is showing on the display.
Press the ENTER button: the values can be changed
Use DOWN and UP buttons to selected the desired mode:
COL.CH7
(COLOR CHANGE 7) 7 colors change automatically without fading.
COL.CH3
(COLOR CHANGE 3) red, green and blue change automatically without fading.
COL.FADE
(COLOR FADE) colors change with a nice fading effect.
Once the correct option shows on the display, press the ENTER button to save it.
Use DOWN and UP buttons to select the desired
playback speed
from 01 (very slow) to 99 (fast).
Once the correct value shows on the display, press the ENTER button to save it.
Use DOWN and UP buttons to select the desired
strobe speed
from 00 (NO strobe) to 99 (fast).
Once the correct value shows on the display, press the ENTER button to save it.
STATIC COLOR MODE
Used to set the desired fixed color while used as master: 9 preset 1 custom color.
Press the MODE button until the desired function is showing on the display.
Press the ENTER button: the values can be changed
Use DOWN and UP buttons to selected the desired color:
COLOR WW
warm white 3200K
COLOR CW
warm white 5600K
RED
ORANGE
YELLOW
