·
3
·
2.1
MOUNTING
UPRIGHT
2
INSTALLATION
The LED Fixture can be mounted in a sitting or wall
mounted position using the supporting brackets.
The LED Fixture should be placed on a non-
flammable flat surface in any orientation and fixed
by screws. There are four holes into the supporting
bracket.
The LED
can be mounted in a hanging
position using the supporting bracket. The bracket
should be secured to the mounting truss or structure
using a standard mounting clamp. Please note that
when hanging the unit a safety cable should also be
used.
fixture
The LED MODULE can be mounted at any angle and in any
position. It is possible to further adjust the angle of the LED
MODULE using the two adjustment knobs located on the side of
the fixture.
HANGING
2.2
SIGNAL CONNECTIONS
Note:
1. If over 25units to be connected, then a DMX signal amplifier is needed.
2. If the signal cable is over 60m between the DMX512 controller and fixture or beween two
fixtures, then a DMX signal amplifier is needed as well.
