ENGLISH
USER MANUAL
BRITEQ
®
5/30
PD-63SH
INSTALLATION GUIDELINES
DANGER TO LIFE / EQUIPMENT:
This unit may only be installed and electrically connected by an
authorized and qualified electrician!
Electrical installation should strictly follow all safety rules and
technical norms for electrical installations in your country!
The complete installation should be approved by an authorized
expert before it will be taken into operation! Each change to an
existing installation should be re-approved as well!
Before connecting ANY equipment you should ALWAYS check the
voltage on the 3 phases: not following this rule can cost you a lot
of money due to broken equipment. Briteq CANNOT be held
responsible in such cases!
MAINS INPUT:
the unit should be connected to the mains via a 5pole 380-400V 63A CEE socket. The
maximum overall power is
44.160
Watt which may never be exceeded!
OUTPUTS:
each phase is connected via
4
separate 16A output sockets. The maximum power per phase
is 14.490Watt, each 16A output socket supports maximum 3.680Watt which may never be exceeded!
MAINTENANCE
DANGER TO LIFE:
Switch the unit off and unplug the mains cable BEFORE servicing!
During inspection the following points should be checked:
All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
Clean with a soft cloth using normal glass cleaning products.
Always dry the parts carefully.
The unit and its installation conditions should be inspected and approved every 3 months by an authorized
expert!
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!