WARNINGS!!!!
LIGHTS ARE FOR UNDERWATER TRANSOM USE ONLY!!!!!
POWER REGULATOR MUST BE USED ON ALL CANYON
LIGHTS.
UNDERWATER MARINE SEALANT (I.E. 3M 4200) REQUIRED.
PROFESSIONAL INSTALLATION IS RECOMMENDED.
3 AMP FUSE MUST BE USED FOR CANYON LIGHT.
SCREWS PROVIDED MAY NOT FIT ALL APPLICATIONS,
VERIFY LENGTH NEEDED BEFORE USE.
WARRANTY WILL BE VOID IF FUSE NOT USED.
1 YEAR WARRANTY FROM TIME OF PURCHASE – REPAIR OR
REPLACEMENT OF LIGHT.
VERIFY ALL DIMENSIONS BEFORE DRILLING ANY HOLES IN
THE BOAT.
Canyon Light Installation
The Canyon Light can be installed two (2) different ways:
Flush Mount with the wire through the Transom
1.
Look inside the boat making sure the area you want to mount the light is Free and
Clear and accessible.
2.
You want to mount the lights to the Transom leaving at least two inches (2”)
between the light and the bottom of the boat.
3.
Following the Template, drill a pilot hole into the Transom approximately 3/16
inch to prevent cracking of the Gel Coat.
