background image

// 

INSTALLATION & USER INSTRUCTIONS

Section

Contents 

Page

1.0

Important Notes

02

2.0

Installation Requirements

03

3.0

Appliance Data for Ashurst Stove

04

4.0

Unpacking the Stove

05

5.0

Component Checklist

05

6.0

Site Requirements

05

7.0

Clearances

06

8.0

Installation – Stove Pipe

07–08

9.0

Operating the Stove

09–11

10.0

Safety Cutout System

13

11.0

Cleaning & Maintenance

14

12.0

Troubleshooting Guide

15

13.0

Spares

15

14.0

Servicing

16

15.0

Ashurst Stove Dimensions

17

16.0

Terms and Conditions

18

// 

1.0 IMPORTANT NOTES

 IMPORTANT – THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE.

When using this electrical appliance, basic 

precautions should be followed to reduce the 

risk of fire, electric shock and injury to person, 

including the following:
This heater must be used on an AC supply only 

and the voltage marked on the heater’s rating 

label must correspond to the supply voltage.
DO NOT switch the appliance on until it is 

properly installed as described in this manual.
This appliance can be used by children aged from 

8 years and above and persons with reduced 

physical, sensory or mental capabilities or lack 

of experience and knowledge if they have been 

given supervision or instruction concerning use of 

the appliance in a safe way and understand the 

hazards involved. Children shall not play with the 

appliance. Cleaning and user maintenance shall 

not be made by children without supervision.
Children of less than three years should be kept 

away unless continuously supervised. Children 

aged from three years and less than eight years 

shall only switch on/off the appliance provided 

that it has been placed or installed in its intended 

normal operating position and they have been 

given supervision or instruction concerning use of 

the appliance in a safe way and understand the 

hazards involved.
Children aged from three years and less than 

eight years shall not plug in, regulate and clean 

the appliance or perform user maintenance.

CAUTION:

 Some parts of this product can 

become very hot and cause burns. Particular 

attention has to be given where children and 

vulnerable people are present.
If the supply cord is damaged, it must be 

replaced by the manufacturer, its service 

agent or similarly qualified persons in order to 

avoid a hazard.
The heater must not be located immediately 

below a socket-outlet.
DO NOT use this heater in the immediate 

surroundings of a bath, a shower or a 

swimming pool.

WARNING:

 In order to avoid overheating, do not 

cover the heater.
DO NOT use this heater with a programmer, timer, 

separate remote-control system or any other 

device that switches the heater on automatically, 

since a fire risk exists if the heater is covered or 

positioned incorrectly.

CAUTION:

 In order to avoid a hazard due to 

inadvertent resetting of the thermal cutout, 

this appliance must not be supplied through an 

external switching device, such as a timer, or 

connected to a circuit that is regularly switched 

on and off by the utility.
Keep furniture, curtains and other fabric material 

away from the appliance.
DO NOT leave the appliance unattended during use.
From time to time, check the cord for damage. 

Never use the appliance if the cord or any part of 

the appliance shows signs of damage.
DO NOT run the mains cable under carpets, rugs etc.
DO NOT cover or obstruct the heater in any way. 

Overheating will result if it is accidentally covered.
Never immerse the product in water or any 

other liquids.
DO NOT use the appliance outdoors.
Before cleaning the appliance, ensure it 

is unplugged from the power and that it is 

completely cool.
DO NOT clean the appliance with abrasive 

chemicals.
N e v e r   u s e   a c c e s s o r i e s   t h a t   a r e   n o t 

recommended or supplied by the manufacturer. 

It could cause danger to the user or damage to 

the appliance.
DO NOT insert or allow foreign objects to enter 

the inlet or outlet vents as this may result in 

electric shock, fire or damage to the appliance.
DO NOT install the fire using an extension cord.
Unplug from the mains supply if the appliance is 

not to be used for long periods.
This product is only suitable for well insulated 

spaces or occasional use.

// 

01

// 

02

© 2019 British Fires

Summary of Contents for ASHURST












Reviews: