Function Setting
- continued
16
(a) Enter setup mode and select the
interface of Learn New ID’.
(b) Press SET to enter the Learn
New ID mode. It will show position of
front wheel and its ID
(c) Press SCAN, select the front
right wheel then press SET to
confirm.
(d) Waiting for transmitting and
receiving.
(e) Keep the sensor into the range
of 10cm from the display.
Repeat the steps to
learn other ID.
(f) The original ID will be replaced
when the system receives a new
one, the setting is finished. The
system will quit Learn New ID mode
automatically in case of no operation
in 1 minute, the ID will not be
exchanged. The system will enter
into next setup interface after
setting or automatic quitting.
Learn New ID
When a sensor is replaced, follow the steps below to learn new ID. For example learn new ID for front right wheel.
