30
IIDT
ool
Change
confi rmation for confi guration stored inside an individual ECU.
If a change to an individual ECU confi guration was made, it will take effect when the user returns to the
ECU list or when the confi guration is changed. When the ON/OFF button is pressed or when certain
confi guration are changed, the following message will be displayed:
«Confi g have changed, upload
to vehicle? Plus to continue, minus to cancel».
If no changes were made, the IIDTool will return to the
ECU list without updating the current ECU.
Change
confi rmation and CCF updating (2005 only)
If a change to the CCF has been made, it will be written to the vehicle when the user exits the Car
Confi guration menu. Upon pressing the ON/OFF button when in the ECU list, the user will be asked if
he wants to update the CCF with the changes made. The following message will be displayed:
«Confi g
have changed, upload to vehicle? Plus to continue, minus to cancel».
If no changes were made, the
IIDTool will return to the menu without updating the CCF.
When updating the CCF, the IIDTool will prompt you with instructions to follow:
•
If your engine is running, the following message will be displayed:
«Engine running. Turn OFF
engine return key to ON».
•
The IIDTool will verify that the voltage is higher than 11.5 V. If not, the operation will be aborted.
• The
message
«Display will turn off 30 seconds, keep key ON all time, press the resume button
to continue.»
will be displayed. Pressing the resume button will start the CCF programming
while pressing the ON/OFF button will cancel.
During this phase, do not turn the key to the
OFF position or disconnect the IIDTool.
•
Once the display turns on again, you will be asked to turn the key to the OFF position and back
to the ON position, once done, press the resume button.
•
The «clearing fault upload success» messages will appear, press the resume button to quit.
•
If the vehicle is
outside
and you want to continue using your IIDTool, start the engine. If the
vehicle is not outside connect the battery to a power supply.
Notes:
During or after a confi guration programming you may experience one or more of the fol-
lowing:
It is normal to see warning lights appear on the display.
(2005 only) The navigation screen will turn off during CCF programming. The radio memory may be
erased.
You may hear a chime coming from the instrument cluster.
GAP Diagnostic 29/01/2013 All right reserved
User manual: V2.17.12, Firmware V2.17.03
Range Rover L322 2002-2005
