Attach the bottom looped end of the tent top straps to the cast hook on the
footpads. Locate the ratchet in the middle of the strap and tighten until the
strap is taut enough to secure the canopy. Repeat this step at the remaining
three corner legs.
Once the top is secured on all corners, fold all extra strap length into the
white vinyl covers with velcro closure.
Step 9
S-SERIES | 20x20
6
Step 10
Step 11
Step 12
Attach tent top to the frame with the tent top straps. Bring the “Y” straps
(located at the very top of the tent top straps) through the metal rings on
each of the tent top valances and secure the looped ends of the “Y” straps
into the carabiner. Fold the valance flap over the “Y” straps where the strips
of velcro line up to finish the corner. Repeat this step at the remaining three
corners. **Do not hook carabiner directly to metal valance rings!**
Once all stakes have been secured and straps ratcheted taut, fold all extra
outguy strap length into the white vinyl covers with velcro closure.
Locate the outguy straps and connect the carabiner at the top of the strap to
the cast eyelet that is on the outside of each of the corner brackets. Locate
the 3’ ground stakes and wrap the looped strap (found at the bottom end of
the outguy straps) around the head of the stake twice. Drive the stakes into
the ground 5’ out from each corner leg and ratchet the strap until it is taut.
Repeat this step on the three remaining corner legs.
