EN
7
Parts
Please retain all packaging until you are certain no parts are missing.
After assembly, please dispose of all packaging carefully, including the caps on the
ends of the legs.
1. Seat Unit
2. Two Part serving tray
3. Front and Rear feet
4. Left and Right legs
5. Stop washer and screw x 2
6. Seat cover
Assembly
Take either the left or right leg (4), press and hold the red button (a) and extend
the leg then release the red button. Take the other leg and follow the above
procedure.
Take the legs and noting the orientation in the diagram insert the legs into the top
of the seat unit adjusting brackets.
To lift the seat unit to the top of the legs simply press and hold the red buttons on
the seat unit adjustment brackets and lift. There are six positions bottom being “6”
and top being “1”.
Fixing the feet
Turn the highchair upside down.
Please note that each of the four legs has a sprung loaded pin.
Line up one of the feet so that the small hole in the top of the foot lines up with
the pin.
Push firmly on the foot at either end until each of the two sprung pins click into
place within the small hole in the foot. Repeat for other foot.
Note the rear foot is indicated by a red circular sticker located on the white plastic
foot.
Take one stop washer and insert the screw then insert into the bottom hole at the
rear of the front left legs and repeat the process on the right leg.
Ftting the seat cover
Slide the pocket of the seat cover back over the curved back frame.
Secure the seat sides by wrapping them around the frame and fastening press
studs (a) at each side of the seat.
Ftting the tray
Position the tray to front of the arms, pull the front lever (a) found on the under
side of the tray, whilst sliding the tray along with the slot (b) to the position
required.
The tray has three positions only as indicated on the armrests, line the tray with
the desired position, release the lever to lock position.
Summary of Contents for Yuki2
Page 2: ......
