285 Issue 1 - Service Manual - Iceberg
35
1. 1.”AUTO COOL”
In “AUTO COOL” mode the Programmable Wall Control automatically operates the cooler
(fan speed and pump) to maintain the selected ‘comfort level’. The cooler may even turn OFF
if the conditions meet the comfort level setting.
Begin by pressing the Power key
to turn the Cooler on. If “AUTO COOL” is displayed,
the system is set for Automatic operation, otherwise:
•
Press the mode key to cycle through the Coolers operating modes, until the “AUTO
COOL” is displayed.
•
Push the
and
keys to select the comfort level you require. The longer the
column, the cooler the settings; the shorted the column , the warmer the setting.
Benefits of using the Brivis Iceberg in “AUTOCOOL” mode in preference to
“MANUAL” mode.
•
Power and water consumption varies in relation to the chosen comfort level.
•
This comfort level cannot be as easily maintained in “MANUAL”mode.
•
In “AUTO COOL” mode the unit operates only when it is required.
•
Enables a set comfort level to be maintained automatically as the outdoor/ indoor
temperature conditions change.
•
Allows you to pre-set the cooler to turn ON early and not let the house build up heat.
•
The outlet airflow noise is kept to a minimum, as the fan speed is only as fast as required
to maintain the set comfort level. Thos slower speed also results in more efficient
saturation of the cooler filter pads, and a cooler outlet air temperature.
2. “MANUAL” mode
“MANUAL” mode operation allows you to manually control the fan speed, the pump is always on.
Begin by pressing the Power
key to turn the Cooler on, If “AMNUAL” is displayed the system
is set for manual operation otherwise;
•
Push the MODE key to cycle through the coolers operation modes.
•
Push the
and
keys to select the fan speed level you require. The larger the column,
the faster the fan speed; the shorter the column, the slower the fan speed.
3. “FAN ONLY” mode
“FAN ONLY” mode operation allows you to manually operate the fan speed only.
•
Push
and
keys to raise and lower the coolers fan speed.
Timer Function
This wall control has a timer function that can delay the operation of the system turning ON/OFF.
If the cooler is operating, you can pre-set the times for the cooler to turn OFF. If the cooler is
OFF you can pre-set the timer for the cooler to turn ON. The timer is set in 1-hour increments,
ranging from 1 to 17 hours.