install - concepts - PixMaster - switcher - CG - clips - controls - team - appendix
FLINT
V1.1
Changing a Key without a Background Change
To add or subtract key layers without changing the background video, repeat all of the
above steps, except in step one, turn off the
[Bgr]
button, as shown below.
When [Bgr]
is turned off the end state of the transition will be shown on the preview monitor, which
will include the same background as currently on program.
4.4.5 Pro Transition Mode
When the background and key layers are selected in the transition section of the control
panel, by default, the buttons/layers are added/selected one at a time leaving the
previously selected layers enabled. For most users this method is acceptable, however
in some cases where rapid execution is necessary, users may prefer to only have the
selected layer active, disabling the previously select layers. This mode is known as Pro
Transition Mode.
Key
1
Bgr
Key
2
Key
3
4.4.5
To Enable Pro Transition Mode:
1.
In BPswitcher, select the
Panel
drop
down menu.
2.
Then
Panel Settings.
3.
Place a check next to
Pro Transition
Mode
, as shown on the right.
Now, any transition layer that is
selected will automatically turn off any
previously select layers.
4.
To disable Pro Transition mode, repeat
step one.
