install - concepts - PixMaster - switcher - CG - clips - controls - team - appendix
FLINT
V1.1
3.
The edges of a DVE box may also have a simple colored border. To apply a
border press the
[DVE Border]
PixButton on the PixPad in Device Control-B. The
panel display will read a border thickness above the 1
st
Knob. Turn the knob to
increase /decrease the border thickness.
4.
To change the border color, press the
[Border Color]
PixButton on the PixPad.
The panel display will read color values for
R
ed,
G
reen &
B
lue. Turn the
corresponding knobs until the desired color is reached.
4.5.3
4.5.3 Multiple DVE Boxes
Two DVE Boxes may be used at once, one on Key 1 and the other on Key 2. This is
known as dual boxes, or a “Split-back”, as shown below. To create dual boxes set one
of them up on Key 1, as described above, and then set up another on Key 2 in the
same way. In the same way six DVE Boxes can also be created by turning the DVE
box command on in each of the six keyers.
NOTE:
In the above illustration, the two DVE boxes are placed on an animated background that is
playing out from the system’s clip store with a crawl placed on the bottom.
Key1 (Ra1, DVE)
BWD:015
Key1 (Ra1, DVE)
R:000 G:000 B:000
