install - concepts - PixMaster - switcher - CG - clips - controls - team - appendix
FLINT
V1.1
6.5.4
7.
Click on the
Apply settings
button to verify
the communication ports. If all ports are
verified correctly, the Select clips… button will
activate, as shown on the right.
8.
Click on the
Select clips…
button and the
Select DDR Clips window will appear, as
shown on the right.
Note that the Select DDR Clips windows may
take up to several minutes, depending on how
many clips are on the external server.
If the DDR/Omneon control is not added to the
current show, the Select Clips button will not
be visible. See section 6.5.3 for adding the
server control to a show.
9.
Select the clips you wish to access from the
panel by clicking on
each clip
individually,
and each it will highlight, as shown.
To deselect a clip, click on it again and it will
revert to white.
The clips that are selected in this window will
appear in all 4 channels of the DDR.
10.
To have all the clips Auto Start, place a check
mark next to
Default to AutoStart
, as shown
on the right.
11.
To have all the clips Auto Loop, place a check
mark next to
Default to AutoLoop,
as shown
on the right.
12.
Click on the
OK
button on the Select DDR
Clips window.
13.
Then click on the
OK
button on the DDR
settings window, to save your clip settings.
NOTE:
When naming your clips on an external server, it is important not to have a name longer than 8 characters
long or UTF-8 or Unicode. The VDCP protocol only supports file names with 8 or less
characters in ASCII