Broadcom
LPe3X00X-IG114-101
9
Emulex LPe31000-Series and LPe32000-Series Adapters
Quick Installation
Guide
Figure 4: Removing the Bracket
5. Remove the bracket, and store it for future use.
6. Align the new mounting bracket tabs with the holes in the adapter.
NOTE:
Be careful not to push the bracket past the
EMI
compression tabs of the
SFP+
cage. Ensure that the
LEDs
are
properly aligned with the holes in the bracket.
7. Reinstall the screws that attach the adapter to the bracket.
8. Reinstall the transceiver by sliding it into the housing. When the latch engages, it clicks.
9. Push the bail back into place.
2.2 Installing the Adapter
To install the adapter:
1. Turn off the computer if hot-plug installation is not supported on the server.
Refer to your server documentation to see if it supports hot plug/hot swap of PCIe adapter cards.
2. Remove the computer case.
3. Remove the blank panel from an empty PCIe bus slot.
See
Section 2.1, Preparing the Adapter for Installation
, to change the brackets if needed. Otherwise, proceed to
Section 2.3, Attaching the Media
.
4. Insert the adapter into an empty PCIe x8 or x16 slot. Press firmly until the adapter is seated.
NOTE:
Make sure that the adapter is in an appropriate PCIe slot that does not interfere with other components or with the
computer case to prevent damage to the adapter.
Summary of Contents for Emulex LPe31000
Page 26: ......
