Broadcom
P411W-32P-UG104
18
P411W-32P PCIe 4.0
User Guide
NVMe Switch Adapter
7.
Configure and install the PCIe (NVMe) devices in the host computer case.
Refer to documentation for the devices
for any preinstallation configuration requirements.
8.
Connect the adapter to the devices.
The adapter connector's pin definitions follow the SFF-9402 specification, and the
cables must support this connector pin definition shown in
Table 7, Internal Connector Pinout
, for cable ordering information. The maximum cable length is 1 meter (39.37 in.).
9.
Replace the cover, and reconnect any cords and cables.
Replace the chassis cover, reconnect any power cords, and
reconnect any network cables.
10.
Power on the system.
The hardware installation of your adapter is complete.
11 Firmware Download Operation
Use the g4Xflash tool to update the firmware on your adapter. Download the g4Xflash tool from the Broadcom download
center,
https://www.broadcom.com/support/download-search
.
Use the following command to download the firmware and manufacturing image to the Flash memory on the adapter.
dl -f
<firmware file>
[-s] [-nv] [-nr] [-wd] [-hr]
Where:
-f
= Firmware image that needs to be downloaded.
-s
= Silent mode. Performs the download operation without confirmation.
-nv
= Ignores or skips image and region validation.
12 Technical Support
For assistance installing, configuring, or running your adapter, contact Broadcom Technical Support at
.
Summary of Contents for P411W-32P
Page 20: ......
