6
Connecting Your Base Station and Phones
Installing the OfficeSuite Simplicity™ system is easy and should only take a few minutes. It is
important that you follow these steps in order. Instructional videos are also available by clicking
on the Help tab on the website or by visiting www.broadviewnet.com/support.
Step 1 - Set up the phone
Assemble the phone by connecting the phone cord to the handset and then to the back of the
phone. Install the stand. Connect the power adapter to the phone and plug it into a wall outlet no
more than 150 feet from the base station.
Step 2 - Set the base station to the registration mode
On the base station, press and hold the Page Key on the side of the base for about seven
seconds until the LED blinks amber and blue. Release the Page Key. The base is now in
Registration Mode.
CAUTION
!
If you press the Page Key and the phones begin to ring, then the base is not in
Registration Mode but rather is in Misplaced Phone Mode. Answer one of the phones
to silence it and repeat step 2 being sure to hold the Page Key until the LED blinks
amber and blue.