=
The material flow rate is adjusted by the positioning of the regulation lever. Consult the
material spreading chart for the appropriate position for the regulation lever.
=
For fine calibration consult the ‘Calibration’ section of the handbook.
=
The lever positions work as follows:-
After consulting the spreading chart, according to the type of material being spread and the
ground speed, move the lever
“A”
along the graduated scale
“E”
, lock the lever in position
with the clip
“D”
.
In order to spread from both sides
(ref. I)
,
“A”
and
“B”
levers must be in the same position,
connected by the grip handle
“C”
.
In order to carry out the spreading only on the left hend side
(ref. II)
, it is necessay to
disconnect the two levers by removing the grip handle
“C”
. Set the lever
“B”
in the correct
position, given by the spreading chart, and bring lever
“A”
towards position 1 in order to
close the shutter on the right hand side.
In order to spread only on to the right hand side
(ref. III)
you have to move the lever
“B”
up
to position 1 and regulate the quantity to spread with the lever
“A”
.
8
ADJUSTING MATERIAL FLOW RATE
Summary of Contents for Wessex Country FS170T
