Page 2
MODEL 757SNC
TYPICAL INSTALLATIONS
(continued)
SUSPENDED CEILINGS
Housing hung with wires - 3-point mount.
3. Set housing aside and drive nails partially into joist at the top of both
keyhole marks.
4. Hang housing from nails and pound nails tight. To ensure a noise-free
mount, pound another nail through the top hole of each mounting tab.
INSTALL THE HOUSING
(continued)
New Construction
Existing Construction
2. In attic, position mounting brackets against joist. Trace outline of housing
on ceiling material.
1. Choose the location for your fan/light in the ceiling. For best possible
performance, use the shortest possible duct run and a minimum number
of elbows.
3. Set housing aside and cut ceiling opening slightly larger than marked.
INSTALL THE HOUSING
1. Choose the location for your fan in the ceiling. For best possible
performance, use the shortest possible duct run and a minimum number
of elbows.
2. Position mounting brackets against joist so that bottom edge of housing
will be fl ush with fi nished ceiling.
Additional positioning feature for 5/8”, 1”, & 1
¼
”
thick ceiling material:
Holes in corners of housing are labeled with various ceiling
material thicknesses. Position housing so bottom edge of joist
is visible through a matched set of holes. The housing is now in
the proper position for that ceiling material thickness.
Additional positioning feature for 1/2” thick ceiling
material:
Bend two tabs, on side of housing, 90° outward. Lift housing until
tabs contact underside of joist.
Mark the keyhole slot on both mounting brackets.
New Construction
- PLEASE NOTE -
THE FOLLOWING INSTALLATION ILLUSTRATIONS SHOW 2 X 6
JOISTS. IF YOU HAVE A TRUSS OR “
I
”-JOIST INSTALLATION,
MOUNT THE VENTILATOR TO THE ADDITIONAL FRAMING
IN THE SAME MANNER. (Additional framing must be a 2 x 6
(minimum height), at least 9-inch long.)
BH0018A
BR0004
BR0005
BR0006
B
OTTOM
EDGE
OF
JOIST
5/8
1
1-1/4
BR0003
T
AB
H
OLES
