MODELS QP330BL • QP330SS • QP330WW
QP336BL • QP336SS • QP336WW
QP342BL • QP342SS • QP342WW
Page 6
12
DUCTED INSTALLATION ONLY:
Remove 3¼” x 10 vertical, 3¼” x 10” horizontal, or 7-inch
round
knockout plate(s)
as appropriate for your ducting
method.
3¼” X 10”
HORIZONTAL
KNOCKOUT
PLATE
3¼” X 10”
VERTICAL
KNOCKOUT
PLATE
7” ROUND
KNOCKOUT
PLATE (also
remove 3¼” x 10”
vertical plate)
7” ROUND
DUCT
PLATE
11
NON-DUCTED INSTALLATION ONLY:
Purchase a set of (2) non-ducted filters for 30” wide hoods
(Model BPPF30) & 36” wide hoods (Model BPPF36) or
a set of (3) non-ducted filters for 42” wide hoods (Model
BPPF42) from your local distributor or retailer. Attach the
non-ducted filters to the aluminum mesh filters following
instructions packed with the non-ducted filters.
FOR NON-DUCTED INSTALLATIONS - Skip to “INSTALL
THE HOOD”.
13
DUCTED INSTALLATION ONLY:
Attach
3¼” x 10” Damper/Duct Connector
(if using 3¼”
x 10” duct) or
7” Round Duct Plate
(if using 7-inch round
duct) over the knockout opening.
Notes:
To accomodate off-center ductwork, the 3¼” x 10” damper/
duct connector can be installed up to ½” on either side
of the hood center and the 7” round duct plate can be
installed up to ½” on either side of the hood center.
Install the 3¼” x 10” Damper/Duct Connector with the
Damper Flap Pivot
nearest the
Top/Back Edge of Hood
.
TOP/BACK
EDGE OF
HOOD
DAMPER
FLAP
PIVOT
3¼” X 10”
DAMPER / DUCT CONNECTOR
9
NON-DUCTED INSTALLATION ONLY:
Remove 2
Screws
holding
Non-Duct Plate
to
Non-Duct
Plenum
and remove plate.
10
NON-DUCTED INSTALLATION ONLY:
Insert short end of
Non-Duct Plate
into Non-Duct
Plenum
Slot
. Attach with 2
Screws
removed in Step 9.
SCREWS
NON-DUCT
PLATE
NON-DUCT
PLENUM
NON-DUCT
PLATE
ç
SLOT
SCREWS
NON-DUCT
PLATE
8
NON-DUCTED INSTALLATION ONLY:
From parts bag: Attach
Non-Duct Diverter
to
Air Box
with 2
Screws
and 2
Washers
.
NON-DUCT
DIVERTER
