background image

Page 4

MODELS   QTXE050C • QTXE090C • QTXE110C • QTXE150C

Key No.

Part No.

Description

1

97016466

Housing

2

97016450

Duct Connector - 6" (152.4 mm)

3

98010102

Wiring Plate

4

99170245

Screw, #8-18 X .375 (2 req’d)

5

97016583

Wire Panel/Harness Assembly

6

99020284

Blower Wheel

7

99080560

Motor (QTXE050C)

99080575

Motor (QTXE090C)

99080578

Motor (QTXE110C)

99080565

Motor (QTXE150C)

8

99100491

Isolator (4 req’d)

9

97016468

Motor Plate

10

99250959

Washer #8 (4 req’d)

11

99260558

Nut, Hex Lock #8-32 (4 req’d)

12

99500397

Insulation (QTXE150C only)

13

99420648

Threaded Stud (QTXE150C only) (4 req’d)

14

99260570

Plastic Nut (QTXE150C only) (4 req’d)

*

97016587

Blower Assembly (QTXE050C)

*

97016731

Blower Assembly (QTXE090C)

*

97016734

Blower Assembly (QTXE110C)

*

97016591

Blower Assembly (QTXE150C)
(includes key nos. 6 thru 14)

15

99140200

Grille Spring (2 req’d)

16

97016756

Grille Assembly (includes key no. 15)

17

99111293

Spacer (2 supplied)

SERVICE PARTS

Order service parts by “Part No.”
- not by “Key No.”

TAB

SERVICE NOTE

To remove Blower Assembly:
Unplug motor (7).
Remove screw (4) from motor
plate (9) flange.
Find the single 

TAB

 on the

motor plate (located next to
the receptacle).
Push up near motor plate tab
while pushing out on side of
housing. Or insert a straight-
blade screwdriver into slot in
housing (next to tab) and
twist screwdriver.

T

HREE YEAR LIMITED WARRANTY

Broan-NuTone Canada warrants to the original consumer purchaser of its products that such products will be free from defects in materials and workmanship for a
period of three (3) years from the date of original purchase. THERE ARE NO OTHER WARRANTIES, EXPRESSED OR IMPLIED, INCLUDING, BUT NOT LIMITED
TO, IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

During this three-year period

, Broan-NuTone Canada will, at its option, repair or replace, without charge, any product or part which is found to be defective under

normal use and service.

THIS WARRANTY DOES NOT EXTEND TO FLUORESCENT LAMP STARTERS  OR TUBES, BULBS OR BATTERIES, FILTERS, DUCT, ROOF CAPS, WALL CAPS
AND OTHER ACCESSORIES FOR DUCTING. This warranty does not cover (a) normal maintenance and service or (b) any products or parts which have been
subject to misuse, negligence, accident, improper maintenance or repair (other than by Broan-NuTone Canada or an authorized representative), faulty installation or
installation contrary to recommended installation instructions.

The duration of any implied warranty is limited to the three-year period as specified for the express warranty.

BROAN- NUTONE CANADA’S OBLIGATION TO REPAIR OR REPLACE, AT BROAN-NUTONE CANADA’S OPTION, SHALL BE THE PURCHASER'S SOLE AND
EXCLUSIVE REMEDY UNDER THIS WARRANTY. BROAN-NUTONE CANADA SHALL NOT BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL OR SPECIAL
DAMAGES ARISING OUT OF OR IN CONNECTION WITH PRODUCT USE OR PERFORMANCE. This warranty supersedes all prior warranties.

To qualify for warranty service, you must (a) notify Broan-NuTone Canada at the address or telephone number stated below (b) give the model number and part
identification and (c) describe the nature of any defect in the product or part. At the time of requesting warranty service, you must present evidence of the original
purchase date.

Date of Installation

Builder or Installer

Model Number and Product Description

 

IF YOU NEED ASSISTANCE OR SERVICE:

For the location of your nearest Broan-NuTone Canada Inc. dealer:

Dial Toll Free: 

1-888-882-7626

Please be prepared to provide:

Product model number • Date and proof of purchase • The nature of the difficulty

Broan-NuTone Canada Inc.

1140 Tristar Drive, Mississauga, Ontario L5T 1H9

BROAN-NUTONE CANADA INC.

99043636A

Summary of Contents for ULTRA SILENT QTXE Series









Reviews: