Brocade Adapters Troubleshooting Guide
85
53-1001582-01
Collecting port data
3
•
Supported class
•
FC frame size
•
Maximum transmission unit (MTU)
•
Target rate limiting (TRL) enabled or disabled status
•
Default rate limit
•
Beaconing status
•
Fibre Channel Initialization Protocol (FCIP) online or offline state
•
Local (factory) port MAC address
•
Fibre Channel address
•
Priority group ID (PGID)
•
Queue depth
•
Interrupt control delay
•
Bandwidth percentage for priority group
•
MAC address for FCoE forwarder
•
Fabric WWN
•
Fibre Channel map ID
•
FCoE forwarder writing or nonwriting mode
•
Maximum speed supported
•
Port operating topology
•
Authentication status, algorithm, group, and error status
Displaying FCoE port properties
To display the HCM FCoE Port Properties panel, use these steps.
1. Select an FCoE port in the device tree.
2. Click the Properties tab in the right pane.
Displaying remote port properties
Use the HCM Remote Port Properties panel to display properties that are associated with the
remote port, such as WWN, node WWN, port name, Fibre Channel address, frame data field size,
online or offline state, role (such as target or initiator), remote device information, QoS priority, QoS
flow, and target ID. Display this properties panel using the following steps.
1. From the device tree, select a remote port.
2. Click the Remote Port Properties tab in the right panel.
If it is a target port, two tabs display in the right pane: Properties and LUNs.
