110
Brocade Adapters Troubleshooting Guide
53-1001582-01
HCM and Installer Message Reference
B
Port <WWN> parameters
update succeeded. Note:
Setting will be enforced
after port disable and
enable.
Occurs when user makes configuration
changes and clicks Apply to save the
configurations.
Information message.
The change has not been
sent to device. Do you
want to commit the
change?
Occurs when user clicks on OK in the Basic
Port Configuration dialog box after making
configuration changes.
Select to commit the change or to
not commit the change.
Port update failed for
port. <Runtime reason>
Occurs when port configuration fails.
Verify if the agent is active.
The changes will take
effect only on port reset.
Occurs when the user adds a new
authentication policy or edits the existing
authentication policy in the Fibre Channel
Security Protocol dialog box.
Information message.
You are about to disable
the Port <WWN>. This
will disable all the
devices on this Port. Are
you sure you want to
continue?
Occurs when port is disabled from the right-
click drop down menu for the port and in the
Basic Port Configuration dialog box.
Warning that disabling the port will
disable all the devices on the port.
Confirm that you wish to do this.
Log Invalid cannot be
configured as Eth logging
level.
Occurs when “Log Invalid” is chosen in the Eth
logging level menu in the Ethernet Parameters
tab of the Basic Port Configuration dialog box.
Set Valid logging level and proceed.
Successfully updated the
parameters for all ports.
Occurs when the configurations done in the
Basic Port Configuration dialog box are
successfully updated using the Apply button.
The configuration will be reflected
only after a successful process.
QoS and Target rate
limiting cannot be
enabled at the same
time.
Occurs when QOS and target rate limiting are
enabled at the same time in the Basic Port
Configuration dialog box.
Do not enable QOS and target rate
limiting at the same time.
The operation will take
effect after you click OK
or Apply on the
Configuration dialog.
Occurs when the user makes configuration
changes in the Basic Port Configuration dialog
box and clicks Apply or OK.
Clicking Apply or OK will make the
configuration changes.
Log Invalid cannot be
configured as Eth logging
level.
Occurs when the user selects Log Invalid from
the Eth Logging Level menu in the Basic Port
Configuration dialog box.
Set valid logging level and proceed.
Log Invalid cannot be
configured as Port
logging level.
Occurs when the user selects Log Invalid from
the Port Logging Level menu in the Basic Port
Configuration dialog box.
Set valid logging level and proceed.
Restore data is
successfully completed.
Please restart HCM for
new data to take effect.
Occurs upon successful restore of backed-up
HCM data.
Information message.
Backup is in progress.
Please Wait.
Occurs when the user initiates a backup
operation using HCM Backup dialog box.
Restore data is in
progress. Please Wait.
Occurs when the user initiates a restore data
operation using the Restore data dialog box.
TABLE 14
Host Connectivity Manager messages (continued)
Message
Cause
Corrective Action or Notes
