Brocade Adapters Troubleshooting Guide
115
53-1001582-01
HCM and Installer Message Reference
B
No matching binary rpm found
Do you want to install noarch rpm?
Note:
- noarch rpm is not recommended for RHEL/SLES.
- noarch rpm requires kernel devel/source rpm and
GCC.
Occurs when a matching
binary rpm is not found.
Click Yes to proceed with
the installation using the
noarch rpm or click No to
stop installation.
System dependencies not available.
GCC and Kernel rpms are required for installing Storage
and Network Driver and HCM and Storage and Network
Driver.
Variable
"LOAD_UNSUPPORTED_MODULES_AUTOMATICALLY" in
/etc/sysconfig/hardware/config file is set to “no”,
please change it to “yes” before continuing installation
otherwise the driver module will not be loaded.
Occurs when you install a
drivers on a Linux system
that does not contain GCC
and Kernel rpm and when
the variable
"LOAD_UNSUPPORTED_M
ODULES_AUTOMATICALLY
" in
/etc/sysconfig/hardware/
config file is set to “no”.
Change the “No” in
variable
"LOAD_UNSUPPORTED_M
ODULES_AUTOMATICALLY"
present in
/etc/sysconfig/hardware/
config file to “Yes.”
Load the GCC and Kernel
rpms onto the system and
install the drivers.
System dependencies not available.
GCC and Kernel rpms are required for installing Storage
and Network Driver and HCM and Storage and Network
Driver.
Variable "allow_unsupported_modules" in
/etc/modprobe.d/unsupported-modules file is set to
“0”, please change it to “1” before continuing
installation otherwise the driver module will not be
loaded.
Occurs when you install
drivers on a Linux system
that does not contain the
GCC and kernel rpm and
when the variable
"allow_unsupported_mod
ules" in
/etc/modprobe.d/unsupp
orted-modules file is set
to “0”
Change the “0” in variable
"allow_unsupported_mod
ules" present in
/etc/modprobe.d/unsupp
orted-modules file to “1.”
Load the GCC and Kernel
rpms on the system, and
install the drivers.
System dependencies not available.
GCC and Kernel rpms are required for installing Storage
and Network Driver and HCM and Storage and Network
Driver.
Occurs when you install
drivers on Linux systems
that do not contain the
GCC and Kernel rpm.
Load the GCC and kernel
rpms on the system and
then install the drivers.
Default module loading setting
Variable
"LOAD_UNSUPPORTED_MODULES_AUTOMATICALLY" in
/etc/sysconfig/hardware/config file is set to “no”,
please change it to “yes” before continuing installation
otherwise the driver module will not be loaded.
Occurs when the variable
"LOAD_UNSUPPORTED_M
ODULES_AUTOMATICALLY
" in the
/etc/sysconfig/hardware/
config file is set to “no”.
Change the “No” to “Yes”
in variable
"LOAD_UNSUPPORTED_M
ODULES_AUTOMATICALLY"
in
/etc/sysconfig/hardware/
config file then continue
installation.
File backup
Successfully backed up
<brcd_initrd_backup_filename> in /boot.
Occurs when Initrd file is
backedup successfully in
/boot.
No action required.
File backup
There is a back up file <brcd_initrd_backup_filename>
already available in /boot. Do you want to overwrite?
Occurs when a backup file
named
<brcd_initrd_backup_file
name> is already
available in /boot
When user wish to
overwrite the existing
backup file press “Yes”
else “No”
TABLE 15
Brocade Adapter Software Installer messages (continued)
Message
Cause
Corrective Action or Notes
