54
Brocade Adapters Troubleshooting Guide
53-1001582-01
Adapter event messages
3
Use this command without parameters to display all zone configuration information (both
defined and enabled).
•
portErrShow
Use this command to display an error summary for all switch ports.
•
portLogShow
Use this command to display the port log for ports on a switch.
•
portLogShowPort
Use this command to display the port log for a specified switch port.
•
portPerfShow
Use this command to display throughput information for all ports on the switch.
•
portStatsShow
Use this command to display hardware statistics counters for a specific switch port.
•
portShow
Use this command to display information and status of a specified switch port, including the
speed, ID, operating state, type, and WWN.
•
SecAuthSecret
Use this command to manage the DH-CHAP shared secret key database used for
authentication. This command displays, sets, and removes shared secret key information from
the databases.
•
sfpShow
Use this command to display detailed information about specific SFPs installed in a switch.
•
show vlan brief
Displays information about a VLAN interface on the switch.
•
show cee maps
Displays information about the configured CEE maps in the switch.
•
switchShow
Use this command to display switch and port information. Output may vary depending on the
switch model. Use this information to determine the fabric port WWN and PID connected to an
adapter port. Also display topology, speed, and state of each port on the switch.
Adapter event messages
When applicable events occur during adapter operation, the adapter driver generates event
messages. These messages are captured in your host system logs. These messages are also
captured in an agtEvent.log file by the HCM and displayed in the HCM master log. Note that
message display may differ in your host system log and the HCM master log, however messages
may contain the following information:
•
Message ID
•
Description
•
Severity level
